Chevrolet : June 6, 2020
Classic styling, twin turbocharged, modern engine controls and ~800whp of pump gas power on tap — for many of us, that’s an absolute dream of a street car, and that perfectly describes Rick’s 1966 Chevrolet Malibu!Obviously, this car and the build is absolutely gorgeous, but had a few issues Rick wanted us to address, along […]
Lancer Evolution | Mitsubishi : June 5, 2020
Jamie brought us his 2006 Mitsubishi Lancer Evolution IX to push it over the 800awhp mark!Up first in the shop, Alex removed the existing fuel pump assembly and Hobbs switch activation setup, and installed a new billet fuel pump hanger assembly from BulletProof Racing loaded with twin 525lph in-tank fuel pumps from Walbro Fuel Pumps, […]
Robert brought us his 2019 Ford Mustang GT to have the Gen-III Coyote 5.0L put under pressure!Up first in the shop, John installed a Gen-V W185RF 3.0L twin-screw system from Whipple Superchargers including a billet Roval 132mm throttle body, billet oil pump gears and crankshaft sprocket from Modular Motorsports Racing – MMR, a set of […]
Cadillac | CTS-V : May 29, 2020
Leo brought us his 2012 Cadillac CTS-V to get it 9-second capable!Up first in the shop, Andrew set the V2 up with a harmonic balancer from Lingenfelter Performance Engineering, pinned crankshaft to eliminate slippage, paired with a 9.17″ lower supercharger pulley from Lingenfelter Performance Engineering to further overdrive the supercharger by 18%, an auxiliary fuel […]
GT350 + bolt-ons + Flex Fuel = ~530whp. That equation is exactly what Zane brought us his brand new Velocity Blue 2020 Ford Mustang Shelby GT350 for!Up first, we started off by performing pre-work dyno pulls to establish our starting point, coming in at a factory-freak level of 486.57whp & 403.10lbft. Then in the shop, […]
100whp+ & 130lbft+: that’s what this 100% stock A90 Supra picked up with a National Speed custom calibration via EcuTek Technologies Ltd!After getting used to the factory power of his 2020 Toyota GR Supra rather quickly, Trey was ready to start turning the wick up. To start, we performed pre-work dyno runs to establish our […]
