Subaru / WRX /

2008 Subaru WRX STI

After experiencing bearing failure, Jason brought his 2008 Subaru WRX STI in to not only get the EJ257 rumbling again, but to also lay the foundation for future modifications! After disassembling the engine to determine the full extent of damage, we discovered that Jason’s quick response to the early signs of bearing failure paid off […]

View Full Post →

2017 Chevrolet Camaro ZL1 – 800HP

It goes without saying that the 650hp/650lbft LT4 engine found in the C7 Corvette Z06, Gen-VI Camaro ZL1, and V3 Cadillac CTS-V is an absolute beast of a power plant. The only drawback? The OEM supercharger is on the smaller size (1.76L), and is already rather highly spun from the factory (~20,000rpm). While there is […]

View Full Post →

2009 Dodge Challenger R/T – Supercharged

Mike brought us his 2009 Dodge Challenger R/T to have the 5.7L Hemi put under a little pressure! Up first, Andrew installed a complete ProCharger P-1SC-1 supercharger system, a 170° thermostat to help keep coolant temperature in check, along with a Barton Industries short-throw shifter assembly to tighten up the shifts. Once Andrew wrapped the mechanical work in the […]

View Full Post →

1994 Toyota Supra – 1,300HP

Chris brought his 1994 Toyota Supra in all the way in from Kentucky for the last step of his TX2K19 preparation: a custom dyno calibration by Vlad via AEM Performance Electronics Infinity 712! Quick rundown of the setup: forged internals (still 3.0L of displacement), Kelford Cams D camshafts, ported cylinder head, Sleeper Designsintake manifold, OEM GM LS3 90mm throttle body, […]

View Full Post →

2019 Subaru WRX STI

Before the first oil change was even due, Justin brought his 2019 Subaru WRX STI in for the first round of work! Starting out in the shop, Louis set the EJ257 up with a COBB Tuning SF intake system, turbocharger inlet tube, down-pipe, 3-port electronic boost control solenoid, complete Flex Fuel conversion kit with pressure sensor, Injector Dynamics ID1050X […]

View Full Post →

2016 Dodge Challenger SRT Hellcat

A few months ago, Ron brought us his 2017 Dodge Challenger SRT Hellcat because he was bored with the stock performance. After sending him home grinning ear-to-ear with 793.43whp & 726.91lbft (check out his build here), that same day we got a call from a gentleman named Chuck, that went something like, “I’ve got the […]

View Full Post →